Indicators. ETAS ES650

ETAS

3.5.2

Hardware Description

Indicators

The three indicators (LEDs) are located in the top left corner on the front panel.

They indicate the following operational states of the ES650.1:

Indicator

ON

Indication green

Operational State

The unit is powered on. green, blinking The unit is in standby mode.

TX

ER t green, pulse, intermittent brightness

The unit is synchronizing with the

ES600.

t yellow Host connection exists. yellow, blinking Data are being transferred. red

(duration > 5 s) red, bright blink ing

-

An error has occurred. Measurement accuracy may be out of specification.

Please send the unit to ETAS for service.

A serious error has occurred. Measure ments are no longer possible. Please send the unit to ETAS for repair. t red, pulse, inter mittent bright ness

Device identification activated from

INCA. t

When enabling the device identification in INCA, the ER LED lights up for 5 s with intermittent brightness. This allows you to identify the device selected in

INCA within a device block.

Serial number

The serial number is located on the front side of the module. This number is important for the unique addressing of the module in the application software.

ES650.1 - User Guide 17