advertisement
▼
Scroll to page 2
of
47
ETAS Technical Data
5.10
Pin Assignment
This section specifies the pin assignment of the electrical connectors of the
ES650.1. All connectors are shown as seen on the front or back panel of the
ES650.1.
NOTE
All shieldings are at case potential. The housings are galvanically isolated from all inputs and outputs. The maximum allowed voltage between the case potential, the inputs and outputs, as well as between all inputs and outputs themselves is 60 V DC / 30 V AC.
5.10.1
Analog Inputs
1 4
2 3
2
3
Pin
1
4
Signal
Uin+
Uin-
GND nc
5.10.2
Thermocouple Inputs
A
Meaning
Input voltage, plus
Input voltage, minus
Case ground free
K
Pin
A
K
Signal
Anode
Cathode
Meaning
Anode of thermocouple (+)
Cathode of thermocouple (-)
ES650.1 - User Guide 34
advertisement
Related manuals
advertisement
Table of contents
- 5 About this Document
- 5 Classification of Safety Messages
- 5 Presentation of Instructions
- 6 Typographical Conventions
- 6 Presentation of Supporting Information
- 6 Scope of supply
- 6 Additional information
- 7 Basic safety notices
- 7 General safety information
- 7 Requirements for users and duties for operators
- 7 Intended use
- 12 Hardware Description
- 12 ES600 Measurement Modules
- 13 ES650.1 A/D and Thermo Module
- 13 Overview
- 14 Features
- 15 Package Contents
- 15 Housing
- 16 Ports and Indicators
- 16 Front Side
- 17 Indicators
- 18 Rear Side
- 19 Maximum Input and Common-Mode Voltages
- 20 Measurement Accuracy
- 22 Getting Started
- 22 Installation and blocking
- 22 General installation recommendations
- 22 Fastening the module onto a carrier system
- 23 Connecting several modules mechanically
- 24 Cabling
- 26 Configuration
- 26 Calibration
- 27 Technical Data
- 27 General Data
- 27 Product labeling
- 28 Fulfilled Standards and Norms
- 28 Environmental Conditions
- 28 Maintenance the Product
- 28 Cleaning the product
- 28 Mechanical Data
- 29 RoHS Conformity
- 29 CE conformity
- 29 UKCA conformity
- 29 KCC conformity
- 29 Taking the Product Back and Recycling
- 30 Use of Open Source software
- 30 System Requirements
- 30 Hardware
- 31 Software
- 32 Electrical Data
- 32 Power Supply
- 32 Host Interface
- 32 Analog Voltage Inputs
- 33 Thermocouple Inputs
- 34 Pin Assignment
- 34 Analog Inputs
- 34 Thermocouple Inputs
- 35 Ethernet Interface, Power Supply
- 35 External Display
- 36 Cables and Accessories
- 36 Measuring Cable
- 36 Measuring Cable with Banana Plugs
- 36 Measuring Cable with BNC Plugs
- 36 Adapter Cable with BNC Plugs
- 37 Ethernet Cable/Power Supply Cable
- 37 Y-Cable (ES650.1 in Stand-alone Mode)
- 38 Connecting Cables to the ES
- 40 Ordering Information
- 40 Accessories
- 41 Calibration
- 43 Configuration
- 44 Contact Information
- 45 Figures
- 46 Index