MP 2555/3055/3555/4055/5055/6055 series Operating Instructions

When Other Messages Appear

When Other Messages Appear

Message

"Firmware update will start.

Press [OK]. It will start automatically after 30 seconds have elapsed."

"Cannot connect with the wireless card. Turn the main power switch off, then check the card."

(A "wireless LAN board" is referred to as a "wireless card".)

• The wireless LAN board was not inserted when the machine was turned on.

• The wireless LAN board was pulled out after the machine was turned on.

The settings are not updated although the unit is detected.

"Failed to read the PDF file." There is a possibility that the

PDF version is not supported by the browser's PDF viewer or an unsupported encryption level is specified.

"Clean the scanning glass.

(Located next to the exposure glass.)"

"Following output tray is full.

Remove paper."

Cause

Automatic firmware update is enabled and it is the time for an automatic update.

The scanning glass or guide plate of the ADF is dirty.

The output tray is full.

Solution

• If you want to start the firmware update, press [OK], or configure the setting so that the automatic firmware update starts automatically in 30 seconds.

• If you do not want to start the firmware update, press [Cancel] before 30 seconds elapse.

• Do not turn off the power switch during the firmware update.

Turn off the power, and then check the wireless LAN board is inserted correctly. After this, turn on the power again. If the message appears again, contact your service representative.

With this machine's browser PDF files other than those whose versions and encryption levels are specified below cannot be viewed.

• PDF version: 1.3-1.7

• PDF encryption level: 128Bit AES or 256Bit AES

Clean the scanning glass or guide plate. See "Maintaining Your

Machine", Maintenance and

Specifications.

Remove paper from the output tray to resume printing. Press [Continue] on the display panel to resume printing.

233