advertisement
DSM250 User’s Manual
Figure 61 – DCR100 Channel Configuration Screen (ALM Mode)
6.6.4.2.1 Label
This entry allows you to assign a text label to the device. This label is visible in Maretron analysis and display products and allows you to easily identify the particular device.
6.6.4.2.2 Operating Mode
The operating mode of each channel may be set to either DCR (DC Relay), in which case the state of the channel is controlled by “Circuit Breaker / Switch” controls in N2KView or “Switch/Breaker” favorite screens in the DSM150/DSM250 displays. This section of the manual assumes the operating mode has been set to “ALM”.
6.6.4.2.3 ALM Instance
This entry allows you to program the instance number for the ALM function. You may use a value between 0 and 15. This instance number is used by the DSM150/DS250 or N2KView when selecting annunciators to sound when programming an alert.
6.6.4.2.4 Test Annunciator
Select this entry to verify functionality of the channel in ALM mode. This will cause the annunciator to sound or light briefly.
6.7 Maretron DSM200 Configuration
You can use the DSM250 to configure other remotely-located DSM200 units by using the Remote
DSM200 configuration menu shown in Figure 62 below. This describes the configuration of the
Maretron DSM200 firmware version 1.10. There is one configurable item for the remote DSM200 configuration and that is “Remote Device Selection…”.
Page 72 Revision 1.4.16a
advertisement
Related manuals
advertisement