Remote Alert Audible. Maretron DSM250-01

DSM250 User’s Manual

Figure 278 – Advanced Configuration

The following parameters may be set.

8.7.1 Remote Alert Audible

If Remote Alerts are enabled, and an active alert is received from another device on the bus, the

DSM250 will respond by adding the Alert to its list of Active Alerts (section 8.1), and sounding the

internal speaker. The sounding of the speaker may be disabled (i.e. only visual indications are displayed) by setting this parameter to Disable. The options here are

• Enable

• Disable

8.7.2 Flashing Screen

As an extra means to gain the operator’s attention to an Active Alert, the DSM250 may be set up to flash the entire screen between Red (for Alarms) or Yellow (for Warnings) and Black. The flashing may be disabled by setting this option to Disable. The options here are

• Enable

• Disable

8.8 Restore Factory Defaults

The Alert parameters of the DSM250 may be restored to the factory defaults by pressing the

Enter button while this item is highlighted. The operator will be prompted to confirm this action before it taken.

Page 236 Revision 1.4.16a

Figure 279 – Restore Factory Defaults Confirmation

Revision 1.4.16a Page 237