Outside Humidity. Maretron DSM250-01

DSM250 User’s Manual

Figure 230 – Setting the Barometric Pressure

Use the Increase and Decrease buttons to select the correct pressure, and the press the Enter button to store it.

6.30.6 Outside Humidity

The Humidity is pre-calibrated before leaving the factory, and should not require adjustment. However the current humidity level may be entered in this screen to re-calibrate the WSO100 should this be required.

Figure 231 – Setting the Outside Humidity

Use the Increase and Decrease buttons to select the correct humidity, and the press the Enter button to store it.

6.30.7 Outside Temperature

The Temperature sensor is pre-calibrated before leaving the factory, and should not require adjustment. However the current temperature may be entered in this screen to re-calibrate the

WSO100 should this be required.

Page 196 Revision 1.4.16a

Figure 232 – Setting the Outside Temperature

Use the Increase and Decrease buttons to select the correct temperature, and the press the Enter button to store it.

Revision 1.4.16a Page 197