Maretron VDR100 Configuration. Maretron DSM250-01

are satisfied with the state of the “Display” setting, press the Enter key ( ) to accept the setting. The USB100 will retain information on devices that have been removed from the bus or powered down (“Offline”) so that when they are placed back on the bus, they will assume their prior “Display” setting.

6.29 Maretron VDR100 Configuration

The DSM250 is capable of performing configuration of the VDR100 Vessel Data Recorder. This

describes the configuration of the Maretron VDR100 firmware version 1.0.1.0. Figure 219 below

shows a screenshot of the VDR100 configuration menu.

Figure 219 – VDR100 Configuration Screen

Advanced Configuration changes some complex parameters within the device, and should only be performed by an advanced user. Typically advanced configuration is only done at installation and should not need to be done while at sea.

Revision 1.4.16a

Figure 220 – VDR100 Advanced Configuration Screen

Page 189