Troubleshooting for Anynet. Samsung LN52B750, LN46B750 - 46" LCD TV, LN40B750

¦

Troubleshooting for Anynet+

Problem

Anynet+ does not work.

I want to start Anynet+.

I want to exit Anynet+.

●

The message ‘Connecting to

Anynet+ device...’ appears on the screen.

The Anynet+ device does not play.

The connected device is not displayed.

●

●

●

●

●

●

●

●

The TV program cannot be recorded.

The TV sound is not output through the receiver.

●

●

●

●

●

●

●

●

●

●

●

●

●

●

Possible Solution

Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devices only.

Connect only one receiver (home theater).

Check if the Anynet+ device power cord is properly connected.

Check the Anynet+ device’s Video/Audio/HDMI 1.3 cable connections.

Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.

Check whether the TV remote control is in TV mode.

Check whether it is Anynet+ exclusive remote control.

Anynet+ doesn’t work in certain situations. (Searching channels, Operating Media Play, Plug &

Play , etc.)

When connecting or removing the HDMI 1.3 cable, please make sure to search devices again or turn your TV off and on again.

Check if the Anynet+ Function of Anynet+ device is set on.

Check if the Anynet+ device is properly connected to the TV and check if the Anynet

CEC) is set to On in the Anynet + Setup menu.

+ (HDMI-

Press the TV button on the TV remote control to switch to TV. Then press the TOOLS button to show the Anynet+ menu and select a menu you want.

Select View TV in the Anynet+ menu.

Press the SOURCE button on the TV remote control and select a device other than Anynet+ devices.

Press z , CH LIST , PRE-CH , and FAV.CH

to change the TV mode. (Note that the channel button operates only when a tuner-embedded Anynet+ device is not connected.)

You cannot use the remote control when you are configuring Anynet+ or switching to a view mode.

Use the remote control when the Anynet+ setting or switching to view mode is complete.

You cannot use the play function when Plug & Play is in progress.

●

●

●

Check whether or not the device supports Anynet+ functions.

Check whether or not the HDMI 1.3 cable is properly connected.

Check whether Anynet + (HDMI-CEC) is set to On in the Anynet+ setup menu.

Search Anynet+ devices again.

You can connect an Anynet+ device using the HDMI 1.3 cable only. Some HDMI cables may not support Anynet+ functions.

If it is terminated by an abnormal situation such as disconnecting the HDMI cable or power cord or a power failure, please repeat the device scan.

Check whether the antenna jack on the recording device is properly connected.

Connect the optical cable between TV and the receiver.

[750-NA]BN68-02111B-Eng.indb 64

English - 64

2009-03-30 �� 1:43:10