![](http://s1.manualzz.com/store/data/007218407_1-361177deffbdca436549d19760fb4425-128x128.png)
advertisement
![Vehicle Data Recorder | Manualzz Vehicle Data Recorder | Manualzz](http://s1.manualzz.com/store/data/007218407_1-361177deffbdca436549d19760fb4425-360x466.png)
VDR Operator's Manual
BUZZER (E)
An audible tone will sound once when the VDR is powered up and when a recording is triggered.
This audible tone will also sound for 60 seconds after power to the VDR is lost. To stop the tone from sounding following power loss, press the Trigger Button on the Pendant.
Note: In the event of power loss to the VDR, the configuration and recorded data are retained.
Pendant Events and Indicators
STATE POWER
GREEN
LINK AMBER
VDR powered, no configuration File
DISPLAY BUZZER
ON OFF Display
VDR powered, IDS downloading configuration
ON
Momentary
Flashing
Display "0" OFF
VDR powered, uploading data to
IDS
Counter-clockwise rotating segment
# of recordings* at the end of upload
OFF
VDR powered, valid configuration
Available
ON OFF # of recordings* Beep once
Initializing communication w/the vehicle
Normal operation w/the vehicle
ON
ON
Flashing
ON
# of recordings*
# of recordings*
OFF
OFF
Trigger detected ON ON # of recordings*
Clockwise rotating segment display,
Beep Once
Saving file in response to trigger
OFF recordings at the end of capture
Blank VDR in sleep mode OFF OFF OFF
Waking up from sleep
Wake-up to sleep transition
Power to no-power transition
ON Flashing # of recordings* OFF
OFF OFF Blank OFF
Beep for 60 sec.
Reflash failure ON OFF Flashing "E" button pressed
Beep 3 or 5 times
* The 7-segment LED, in addition to displaying the number of recordings will flash if the
maximum number of recordings has been reached.
20
advertisement
Related manuals
advertisement
Table of contents
- 3 Contents
- 4 Definitions, Acronyms, and Abbreviations
- 5 Introduction
- 6 System Components
- 6 Standard Equipment
- 7 Safety
- 7 Proper Installation and Use of this Equipment
- 8 Equipment Precautions
- 8 IMPORTANT SAFETY INSTRUCTIONS
- 10 Using the VDR
- 10 Vehicle Identification
- 10 Identifying a New Vehicle
- 11 Manual Vehicle Entry
- 12 VDR Set-up from IDS
- 14 Parameter Selection
- 15 Recording Time Set-up
- 16 Trigger Set-up
- 17 Download to VDR
- 19 Hook-up to Vehicle
- 20 Control of VDR/Manually Recording Data
- 20 User Interface (Pendant)
- 22 Pendant Events and Indicators
- 23 VDR Upload to IDS
- 24 File Naming
- 24 Playback
- 28 Technical Specifications
- 28 Vehicle Data Recorder (VDR)
- 28 Environmental Specifications
- 28 Vehicle Communications Link Interface
- 29 VDR Connectors
- 30 Care and Maintenance
- 31 Troubleshooting
- 31 Simple Checks
- 31 VDR System Diagnostics
- 33 Warranty
- 34 VDR Support
- 34 WEB BASED TECHNICAL INFORMATION SUPPORT REQUEST