COMMISSIONING. EKOM DK50 2V

INSTALLATION

•

Connect the cabinet pressure gauge to the compressor per Chapter 11.2.

•

Connect the display in the front door of the cabinet (Fig. 15), and secure the cord to the display in the clamps (Fig. 16).

Fig. 15: Connecting the display connector

Fig. 16: Position of the clamps in the cabinet

14. COMMISSIONING

•

Check if all fixing elements used during transport have been removed.

•

Check correct connection of compressed air (see chapter 11).

•

Check correct connection to the mains (see chapter 12)

• Check position of the circuit breaker switch, it must be in position „I“. If it is in position „0“, turn the switch (2

) to position „I“ (Fig. 17)

•

On compressor in the cabinet, switch the switch (5) on the front side of the cabinet to position

„I“, the green light indicates the device status in operation. (Fig. 17).

12/2022 31 NP-DK50 2V-A-5_12-2022-AD