Code Autosearch. RCA RCU1010RF

RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 12

Code Search (continued)

5. Press and release the desired component key (TV, VCR, SAT, etc.). For AUX, press and release the LCD AUX key followed by the desired component key to be programmed under that key.

Note:

The AUX key automatically defaults to Cable Mode unless another selection is made.

6. The LCD displays the Code Search Key? Screen. Press and release the ON•OFF key repeatedly until the component to be controlled responds to the command and turns off. The current code being sent is displayed in the right-hand corner.

Note:

The Code Search starts from the currently stored code under that mode. For example, if the component Code List contains 100 codes and the currently stored code is 050, the

Code Search starts from 051 and continues to 100 before looping back to 000 and finishing at 050. This speeds up the process of finding the correct code for your component, since you may discover that some codes can turn your component on and off but are not able to control its other functions. This process allows you to bypass codes you’ve already tried.

7. Press and release the LCD OK key to save the code. After you install this code, all key labels and any previously Learned commands will be reset.

8. If your component responds and you accidentally overshoot that code by pressing the ON•OFF key again, press and release the CH- key or LCD DOWN ARROW key to backtrack through the Code List. You can change the direction to forward once again by pressing the ON•OFF, CH+, or LCD

UP ARROW

keys.

9. After pressing the LCD OK key in step 7, the LCD displays the Code Search Mode? Screen. The Code Search Method entry is now complete. To exit the Setup Mode, press and release the LCD EXIT key, followed by the LCD OK key on the Exit Setup Screen.

Code Autosearch

Your RCU1010RF has the ability to automatically scroll through the entire Code Lists by using the Autosearch feature. Remember: Code Autosearch may take some time to cycle through all available codes. Be sure the remote control unit is pointed at the component you are programming.

To start a Code Autosearch, follow these steps:

1. Manually turn on the component to be controlled (TV, VCR,

DVD, PVR/DVR, etc.).

2. Press and hold the SETUP key on the rubber keypad for 2-3 seconds until the LED indicator light remains on and the touchscreen shows the Code Setup Mode? Screen.

3. Release the SETUP key.

4. Press and release the SETUP key again. The LCD displays the Code Search Mode? Screen.

5. Press and release the desired component key (TV, VCR, SAT, etc.). For AUX, press and release the LCD AUX key followed by the desired component key to be programmed under that key.

Note:

The AUX key automatically defaults to Cable Mode unless another selection is made.

6. The LCD displays the Code Search Key? Screen. Keep the remote pointed at the component as you press and release the

ON•OFF

key once. If you do not press any other keys, the

Autosearch feature automatically starts in six seconds.

12