Code Identification. RCA RCU1010RF


Add to My manuals
78 Pages

advertisement

Code Identification. RCA RCU1010RF | Manualzz

RCU_1010_RF_IB_RevA.qxd 9/24/03 10:30 AM Page 13

7. The Autosearch sends the next code in the list every three seconds. The current code being sent is displayed in the upper right-hand corner.

8. To speed up the Autosearch, you can manually override the process and temporarily speed it up by pressing the normal search keys (CH+, CH-, ON•OFF, LCD UP and DOWN

ARROW

) in both forward and reverse directions.

9. Once the component to be controlled responds to the commands, press and release the LCD OK key to save the code. After you install its code, all key labels and any previously Learned commands will be reset.

Note:

If your component responds to the command, and the

RCU1010RF sends the next code before you have a chance to press and release the LCD OK key, you can backtrack through the Code List by pressing CH- or the LCD DOWN ARROW.

You can change the direction to forward once again by pressing the ON•OFF, CH+, or LCD UP ARROW keys.

10. After pressing the LCD OK key in step 9, the LCD displays the

Code Search Mode? Screen. Code Autosearch is now complete.

To exit the Setup Mode, press and release the LCD EXIT key, followed by the LCD OK key on the Exit Setup Screen.

Code Identification

Code Identification allows you to find out what code is currently programmed in the remote under a given mode (TV, VCR, DVD, etc.).

To find the currently programmed code, follow these steps:

1. Press and release the SETUP key. The last active screen that was displayed appears.

2. Press and hold any LCD component key. The top right corner of the LCD touchscreen shows the current code programmed for that component.

Code Identification Chart

Enter your codes here for easy reference:

TV CODE AUX component:______

Tuner

AUDIO 1

CD

Tape

AMP

VCR CODE

Tuner

AUDIO 2

CD

Tape

AMP

(Also use for PVR/DVR)

SAT CODE

Tuner

AUDIO 3

CD

Tape

AMP

DVD CODE

Tuner

AUDIO 4

CD

Tape

AMP

NOTE:

Cable Mode is the default for AUX.

13

advertisement

Key Features

  • Universal remote control with touchscreen
  • Built-in RF transmitter for long range control
  • Remote sender cone for controlling devices out of sight
  • IR extender for controlling devices in hard-to-reach places
  • Easy-to-navigate touchscreen menu
  • 90-day limited warranty

Related manuals

Frequently Answers and Questions

How do I set up the remote sender cone?
Plug the remote sender cone into an electrical outlet and then connect the other end to the back of the RCU1010RF.
How do I set up the IR extender?
Plug the IR extender into an electrical outlet and then connect the other end to the back of the RCU1010RF.
How do I install the batteries?
Open the battery compartment on the back of the RCU1010RF and insert two AA batteries.
How do I use the touchscreen menu?
Touch the screen to select the desired function.
How do I control devices from another room?
Use the built-in RF transmitter to control devices from anywhere in the room, even if there are obstacles in the way.
Download PDF

advertisement