12.2. SMS Text Message. Eldes EKB3

The system will arm/disarm the partition corresponding to the one that the user phone number is assigned to. For more details on how to set user phone number partition, please refer to 23.2. User Phone Number Partition.

30

CALL

User ESIM264

12.2. SMS Text Message

SMS

To arm the system by SMS text message, send the following text to the system‘s phone number from any of 10 available user phone numbers (see 8. USER PHONE NUMBERS for user phone number management). When the SMS text message for arming is sent to the system’s phone number, the system will proceed as follows:

• Non-partitioned system:

• If ready (no violated zone/tamper), the system will arm.

• If unready, the system will not arm and provide a list of violated zones/tampers by SMS text message to user phone number.

• Partitioned system:

• If all partitions are disarmed ready (no violated zone/tamper), the system will arm them.

• If one or more partitions are disarmed unready (violated zone/tamper is present), the system will arm the ready partition (-s) and skip the unready one (-s). The system will then send an SMS text message, containing a list of violated zones/tampers, to user phone number that the system arming was initiated from.

• If a combination of armed and disarmed ready partitions is present, the system will arm the disarmed ready partitions and skip the armed ones.

Arm the system

SMS text message content: ssss_ARMp or ssss_ARMp,p

Value: ssss – 4-digit SMS password; p – partition number, range – [1 – Partition 0, 2 – Partition 1].

Example: 1111_ARM1

31

SMS

User ESIM264

To disarm the system by SMS text message, send the following text to the system‘s phone number from any of 10 available user phone numbers:

Disarm the system

SMS text message content: ssss_DISARMp or ssss_DISARMp,p

Value: ssss – 4-digit SMS password; p – partition number, [1 – Partition 0, 2 – Partition 1].

Example: 1111_DISARM1,2

32

SMS

User ESIM264

MANUAL ELDES ESIM264 V3.1

EN