19.2. Wireless Device Information and Signal Status Monitoring. Eldes EKB3

ATTENTION: In order to correctly remove the wireless device from the system, the user must remove the device using SMS text message or ELDES Configuration Tool software and restore the parameters of the wireless device to default afterwards. If only one of these actions is carried out, the wireless device and the system will attempt to exchange data to keep the wireless connection alive. This leads to fast battery power drain on the battery-powered wireless device.

19.2. Wireless Device Information and Signal Status Monitoring

Once a wireless device is bound, the user can view the following information of a determined wireless device:

• Battery level (expressed in percentage).

• Wireless signal strength (expressed in percentage).

• Error rate (number of failed data transmission attempts in 10-minute period).

• Firmware version.

To view the wireless device information, please refer to the following configuration methods.

View wireless device information

SMS

EKB2

SMS text message content: ssss_RFINFO:wless-id or ssss_RFINFO:Znn

Value: wless-id – 8-digit wireless device ID code; nn – wireless zone number, range – [13...

76].

Example: 1111_RFINFO:535185D

Menu path:

Battery level: OK → CONFIGURATION → OK → aaaa → OK → WIRELESS DEVICES → OK → wless-dev wless-id → OK → BATTERY

Wireless signal: OK → CONFIGURATION → OK → aaaa → OK → WIRELESS DEVICES → OK → wless-dev wless-id → OK → SIGNAL

Error rate: OK → CONFIGURATION → OK → aaaa → OK → WIRELESS DEVICES → OK → wlessdev wless-id → OK → ERROR RATE

Firmware version: OK → CONFIGURATION → OK → aaaa → OK → WIRELESS DEVICES → OK → wless-dev wless-id → OK → FW RELEASE

Value: aaaa – 4-digit administrator password; wless-dev – wireless device model; wless-id

– 8-digit wireless device ID code.

Config

Tool

This operation may be carried out from the PC using the ELDES Configuration Tool software.

The system supports up to 16 wireless devices. To view the number of unoccupied wireless device slots in the system, please refer to the following configuration methods

View unoccupied wireless device slots

SMS

SMS text message content: ssss_STATUS_FREE

Example: 1111_STATUS_FREE

Config

Tool

This operation may be carried out from the PC using the ELDES Configuration Tool software.

When the wireless signal between the system and a wireles device is lost and does not restore during 20 minute period, the system will send notification by SMS text message to preset user phone number. By default, the notification regarding the wireless signal status is enabled. To disable/enable this notification, please refer to 16. TAMPERS.

MANUAL ELDES ESIM264 V3.1

EN