advertisement
16
En
01_SVM-1000_En.book 16 ページ ２００７年１０月１６日 火曜日 午前９時２２分
USING THE VIDEO FADER FUNCTION
OPERATING IN THE SOLO MODE
When solo mode is ON, the border of the selected channel preview monitor will become white and the video of the touched channel will be output independently. Switching can be used to change the video.
By combining with the FADER AV SYNC button ON/OFF, a variety of operations is possible.
Whenever the power is first turned ON, the solo mode is set to OFF by default.
When the solo mode is ON, the solo mode button will flash.
Solo mode ON
When FADER AV SYNC is ON
• Touching the channel monitor will independently output the video of the selected channel.
• The video image will change together with the timing of the channel fader operation.
When FADER AV SYNC is OFF
• When the channel monitor is touched, the touched video will be output independently.
Upon changing the FADER AV SYNC from ON to OFF, the original channel fader position will be maintained until the channel monitor is touched again.
Operation of the video cross fader and [ TRANS ] button are not supported in the SOLO mode.
VIDEO MIX EFFECTS CHART
Video mix effects
No Name
1 FADE
2 WIPE
3 SWITCH
4 CHROMA-B
5 CHROMA-G
6 LUMINANCE
Description of the effect
Switches video while mixing.
Switches video while wiping away.
Switches instantaneously (without mixing).
Switches video by making the video transparent starting from its blue components and combining the videos.
Interchanges by making the video transparent starting from its green components and combining the videos.
Interchanges by making the video transparent starting from sections with low luminosity and combining the videos.
advertisement