advertisement
![CE NOTICE. Telit Communications S.p.A. RI7T56KL1 | Manualzz CE NOTICE. Telit Communications S.p.A. RI7T56KL1 | Manualzz](http://s2.manualzz.com/store/data/063080919_1-208f9b580c0a74ee20c86a29d66e9fcf-360x466.png)
1.6
CE NOTICE
Receivers of the APS-NR2 family carry the CE mark and are as such compliant with the 2004/108/EC -EMC Directive and amendments, 2006/95/EC - Low Voltage Directive, both amended by the CE marking directive 93/68/EC.
With regards to EMC, these devices are declared as class B, suitable for residential or business environment.
CE RF exposure compliance
1.7
ROHS/WEEE NOTICE
This device meets the EU requirements (1999/519/EC) and the
International Commission on Non-Ionizing Radiation Protection
(ICNIRP) on the limitation of exposure of the general public to electromagnetic fields by way of health protection.
To comply with the RF exposure requirements, this equipment must be operated in a minimum of 20 cm separation distance to the user.
Receivers of the APS-NR2 family comply with European Union (EU)
Directive 2002/95/EC on the restriction of the use of certain hazardous substances in electrical and electronic equipment
(RoHS Directive).
Receivers of the APS-NR2 family comply with the European Union
(EU) Directive 2002/96/EC on waste electrical and electronic equipment (WEEE). The purpose of this Directive is the prevention of waste electrical and electronic equipment (WEEE), and in addition, the reuse, recycling and other forms of recovery of such wastes so as to reduce the disposal of waste. If purchased in the European Union, please return the receiver at the end of its life to the supplier from which it was purchased.
8 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output