advertisement
4.2
Insert the micro SIM card
Turn off the APS-NR2 to install or remove the SIM card. Damage to the SIM card may occur if installed or removed while power is on
1.
Put the APS-NR2 on a flat surface with its battery compartments facing up as shown
2.
Open the battery compartment.
3.
Open the SIM card compartment
4.
Put the micro SIM card down in the SIM card compartment.
5.
Slide the micro SIM card gently towards the front panel of the APS-NR2 until a click sounds.
6.
Gently close the SIM card compartment.
4.3
Insert the batteries
1.
Place the two batteries in their compartments with their positive leads pointing to the front panel of the APS-NR2.
2.
Close the two battery doors.
The doors click audibly when latched.
4.4
Switch on the APS-NR2
Click the power button once to switch on the APS-NR2.
4.5
Wait for the APS-NR2 to start up
It takes about two minutes for the APS-NR2 to start up.
It is advised to avoid clicking the power button during the start up sequence.
During the start up test sequence the LEDs will blink before they stabilize and indicate the status correctly.
4.6
Make sure the Wi-Fi radio is switched on
The default way of configuring the APS-NR2 is using the Web Interface over Wi-Fi.
1.
If the Wi-Fi radio is already switched on, the Wi-Fi LED is lit.
2.
If the Wi-Fi LED is not lit, click the Power Button twice briefly.
The Wi-Fi LED will switch on, indicating the radio is now active.
Figure 7: APS-NR2 Wi-Fi On-Off
1 9 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output