advertisement
![Configure as NTRIP client. Telit Communications S.p.A. RI7T56KL1 | Manualzz Configure as NTRIP client. Telit Communications S.p.A. RI7T56KL1 | Manualzz](http://s2.manualzz.com/store/data/063080919_1-208f9b580c0a74ee20c86a29d66e9fcf-360x466.png)
5.2
Configure as NTRIP client
1.
Make sure you have a cellular connection as described in the previous section.
2.
Select the tab on the APS-NR2's Web Interface.
Figure 13:NTRIP tab of the Web Interface
3.
Select 'Client' in the Mode drop down box.
4.
Enter the Caster server name or IP address and the Port of your CORS.
5.
Enter the User Name and Password of your account.
The NTRIP password will automatically be encrypted and not shown for security.
6.
Once the NTRIP Mode, Caster, and Port are entered, the Mount Point drop down box will be populated.
Figure 14: NTRIP Settings
7.
Select a Mount Point in the drop down box.
8.
Click OK
9.
The APS-NR2 will automatically initialize and connect.
2 4 | P a g e
Figure 15: NTRIP Initialization
If the Mode Field is set to ‘Client’, the APS-NR2 will auto-connect to the NTRIP Caster each time it is powered.
If the Mode Field is set to ‘Off’, no corrections will be received and the APS-NR2 will not auto-connect to the caster when switched on.
2 5 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output