advertisement
![Set up the cellular modem. Telit Communications S.p.A. RI7T56KL1 | Manualzz Set up the cellular modem. Telit Communications S.p.A. RI7T56KL1 | Manualzz](http://s2.manualzz.com/store/data/063080919_1-208f9b580c0a74ee20c86a29d66e9fcf-360x466.png)
5.1
Set up the cellular modem
1.
Click the tab on the Web Interface to show the status of the Cell Modem.
2.
Enter a Cellular PIN, APN, Username and Password from this tab.
3.
Make sure the 'on' radio buttons of both Power and Connect are selected.
4.
Click OK
Figure 10: Cellular Status : Cell disabled
If the connection has been established successfully, the Status will change from
Initializing Connecting
Connected as shown in Figure 11 and Figure 12.
The line on the left hand will turn green and indicate the connection type (e.g. HSPA) and Status fields
on the bottom right of the page will be filled as shown in Figure 10.
Figure 11: Cellular Status: Getting connected
2 2 | P a g e
Figure 12: Cellular Status: Connected
2 3 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output