advertisement
![APS-NR2 Overview. Telit Communications S.p.A. RI7T56KL1 | Manualzz APS-NR2 Overview. Telit Communications S.p.A. RI7T56KL1 | Manualzz](http://s2.manualzz.com/store/data/063080919_1-208f9b580c0a74ee20c86a29d66e9fcf-360x466.png)
3 APS-NR2 Overview
This section will guide the user through the main parts of the APS-NR2. The detailed steps how to configure the APS-NR2 will be elaborated in later sections.
3.1
Front Panel
The APS-NR2 has an intuitive front panel with status LEDs and the power button.
Figure 2: APS-NR2 Front Panel
The table below provides a brief overview of the LED indications.
A complete table is provided in section "12.2 Front Panel LEDs" on page 47.
Function Indication
Battery Power Level
Battery Power level (Green to Red) solidly lit = battery is in use, blinking = battery is not in use
Bluetooth is off (not lit), connecting (blinking), Paired (blue) Bluetooth (not) paired
Wi-Fi On/Off
Cellular Modem Status
Position Mode
Differential Corrections
Data Logging
Wi-Fi On (Green) or Off (not lit)
The modem is not in use (not lit), connecting (orange), connected
(green) or there is an error in the connection (red)
The reported position is “RTK Fixed” (green), Stand alone (red), any other mode (orange) or no position can be calculated (not lit)
Differential Corrections are being received (Green) or differential Corrections are not being received (not lit)
Logging is disabled (not lit), active (green)
Table 3: APS-NR2 : Front LED – Short
1 3 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output