Configuring the output. Telit Communications S.p.A. RI7T56KL1

6 Configuring the output

6.1

Connect Bluetooth

The APS-NR2 uses its Bluetooth connection to output data to an application running on a tablet, phone or computer.

Before starting the procedure below, it is advised to get acquainted with the procedure of your device (phone, tablet, computer) to connect to a Bluetooth accessory (APS-NR2).

1.

Select the tab on the APS-NR2's Web Interface.

2.

The Bluetooth tab shows the Device name and Pairing code you need to connect to your device consuming the data produced by the APS-NR2

3.

Using your preferred device, select the Bluetooth application and find the Bluetooth device name of your APS-NR2 and

Execute the pairing sequence.

By default the Bluetooth Device name is APS-NR2-<Serial Number>.

4.

The Bluetooth name of the device you connected to appears on the right hand side of the Bluetooth icon in the Bluetooth tab.

5.

Using your preferred GIS or Survey application on the device make sure you connect to the Bluetooth port created by the Bluetooth manager of your device.

Unless there are specific reasons to make the APS-NR2 undiscoverable, it is advised to leave the Discoverable option switched on.

The device name and pairing code may be changed for user preference. Also, the

Bluetooth module may be powered on/off and set to discoverable from this tab.

Figure 17: Web Interface Bluetooth

2 7 | P a g e