advertisement
1.8
FCC Regulations
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user‘s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
1.8.1
FCC RF Exposure Compliance
This equipment complies with radio frequency (RF) exposure limits adopted by the Federal
Communications Commission for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body.
9 | P a g e
advertisement
Related manuals
advertisement
Table of contents
- 5 Introduction
- 5 Foreword
- 6 APS-NR2 Technical Characteristics
- 7 User Notice
- 7 Warranty
- 8 Technical Support
- 9 CE NOTICE
- 9 ROHS/WEEE NOTICE
- 10 FCC Regulations
- 11 IC Regulations
- 12 Safety Information
- 13 Shipping Case Contents
- 14 APS-NR2 Overview
- 14 Front Panel
- 15 Power Button Functions
- 16 Location of Batteries and SIM card
- 16 Closing the battery door
- 17 APS-NR2 Connector
- 18 The Web Interface
- 19 Initial set up
- 19 Prerequisites
- 20 Insert the micro SIM card
- 20 Insert the batteries
- 20 Switch on the APS-NR
- 20 Wait for the APS-NR2 to start up
- 20 Make sure the Wi-Fi radio is switched on
- 21 Connect to the Web Interface
- 22 Basic Configuration of the APS-NR2 for RTK
- 23 Set up the cellular modem
- 25 Configure as NTRIP client
- 27 APS-NR2 Configured for RTK
- 28 Configuring the output
- 28 Connect Bluetooth
- 29 Configure the NMEA for Bluetooth output