Connect to the Web Interface. Telit Communications S.p.A. RI7T56KL1

4.7

Connect to the Web Interface

Any device with Wi-Fi can connect to the APS-NR2 and use the Web Interface.

The APS-NR2 identifies itself as wireless network or an access point.

Before starting the procedure below, it is advised to get acquainted with the procedure of your device (phone, tablet, computer) for connecting to a Wi-Fi network.

1.

Ensure the APS-NR2 is fully booted (about 2 minutes).

2.

Ensure the Wi-Fi is enabled on the APS-NR2 as described in section 4.6 on page 19.

3.

Using your preferred device, select the Wi-Fi application and find the wireless network called APS-NR2-<Serial Number>.

4.

The default password is empty.

5.

Open a browser and type the default IP ‘192.168.20.1’ in the address bar

6.

The browser will land on the tab of the APS-NR2 Web Interface.

Figure 8: Web Interface Overview Tab

2 0 | P a g e