Introduction to the electronic cam module
Functions for the module’s software implemention.
General
Description of the Functions
PL7 software is used for the software implementation of the TSX CCY 1128 module.
The following table describes the functions specific to the electronic cam provided by PL7 for implementing a TSX CCY 1128 module.
Functions Description Operating mode of the terminal
Configuration Used for entering the configuration parameters of the module: l acquisition: type of encoder, reading format, type of recalibration, type of l l capture...
cam processor: resetting the tracks, performance with errors...
connector: inversion of the tracks.
Adjusting the recipe
Used for entering the adjustment parameters of the recipe: l acquisition: number of points per cycle, play, recalibration value… l cam processor: association of the cams with the tracks, track parameters, cam parameters, etc l Parts counter: threshold
Adjustment
Local or connected
Local or connected
Used to modify certain adjustment parameters of the module recipe without stopping the cam processor: l l acquisition: play, recalibration value, cam processor: anticipation factor, thresholds and values of cam time delays.
Connected
Operating mode of the cam processor
Stop
Stop
Stop or Run
22
TLX DS 57 PL7 xx
Introduction to the electronic cam module
Functions
Debugging
Description
Used to execute the following commands: l l l enabling cams, enabling, forcing outputs, enabling, activating recalibration functions, capturing.
It can also be used to display the following statuses: position reading, inputs, etc, and to perform module and application diagnostics.
Operating mode of the terminal
Connected
Operating mode of the cam processor
Stop or Run
TLX DS 57 PL7 xx
23
