Debugging and adjusting
Description of the debugging screen
Accessing the debugging screen
On the screen corresponding to the module, the pull-down menu can be used to select the debugging mode when the PLC is connected.
TSX CCY 1128 [RACK 0 POSITION 3]
Adjusting the Recipe
Configuration
Adjusting the Recipe
Adjustment
Debugging
EC. 128 CAMS
Debugging screen
This screen is used to find out: l l l the module status, by displaying the various errors which may have arisen the present status of the application-specific function, forcing the track commands, performing recalibrations, setting the module to
RUN or to STOP, and confirming or locking the track action on the outputs.
l the status of the cam processors, locking the outputs,
It can be used to reactivate protected outputs and acknowledge errors.
104
TLX DS 57 PL7 xx
Debugging and adjusting
4
Description This screen is made up of 5 parts:
TSX CCY 1128 V1.0 IE 15 [RACK 0 POSITION 5]
Debugging
Designation: 2 CH.COUNTER.MEASUREMENT Version: 1.0
RUN ERR IO
Symbol:
Function:
Electronic cam
Task:
MAST
CH0
Electronic cam
01
Acquisition
Cam processor
Parts counter
Connector0
Connector1
Debugging: Cam processor Parts counter
Counter
Reset counter:
Confirmation:
Maximum value:
Current value:
1
0
DIAG...
DIAG...
Axis:
Angle: 0
Movement direction: pulses No. of cycles: 0
Reset connector 0:
Speed:
Reset connector 1:
0
Recalib pulses/
Parts counter
Full:
Cam processor
ON: Run cam pgm: Confirm track outputs: Fault acknowledgement:
3
1
2
5
This table describes the different parts:
4
5
2
3
Address Description
1 Module status zone.
Channel status zone.
Debugging zone for the selected function.
Browser zone: used to select a function.
Main debugging zone: used to access the main objects
TLX DS 57 PL7 xx
105
