Debugging and adjusting
Description of the adjustment zone
Adjustment zone:
"Acquisition"
The "Acquisition" function is selected in the browser.
Electronic cam
01
Acquisition
Cam processor
Parts counter
Connector0
Group0
Group1
Connector1
The only values that can be modified are the values for the play of the axis, the value of the angle of recalibration and the number of cycles. In these screens: whatever is displayed in blue can be modified.
Adjustment parameters: Acquisition
Axis
No. of pulses/cycle:
Initial value
Number of the cycle:
Initial value
Axis play value:
Initial value
256
256
1
1
25
25 pulses
Recalibration
Value of the angle:
Initial value:
Value of no. of cycles: 0
Initial value: 0
132
0 pulses
Adjustment zone: "parts counter"
Opening via the browser:
Electronic cam
01
Acquisition
Cam processor
Parts counter
Connector0
Group0
Group1
Connector1
In this screen the maximum value of the parts counter can be modified.
Adjustment parameters: Cam processor. Parts counter
Parts counter
Threshold:
Initial value:
20
1
TLX DS 57 PL7 xx
115
Debugging and adjusting
Adjustment zone: "track"
Opening via the browser:
Electronic cam
01
Acquisition
Cam processor
Parts counter
Connector0
Group0
Group1
Track0
Track1
Track2
For each selected track, it is possible to assign to it, (modify), a factor of anticipation.
The value will be a number of steps of 50 micro seconds.
Adjustment parameters: Cam processor. Connector0. Group0. Track0
Auxiliary functions
Anticipation factor:
Initial value:
EVT track
Initial value
0
0
Application inverts on output
Initial value
Parallel track
Initial value
* 50µ s
Action on the parts counter
Forward:
Initial value:
Reverse:
Initial value:
No action
No action
No action
No action
116
TLX DS 57 PL7 xx
Adjustment zone: " cam"
Debugging and adjusting
Opening via the browser:
Connector0
Group0
Track0
Cam0 P(0, 0, 0)
Cam1 M(100, 0, 1)
Cam2 F(150, 200, 0)
It is only possible to open configured cams.
Thresholds X1, X2 and the time delay value can be modified. The initial value is given for information and allows you to return easily to the previous conditions.
Adjustment parameters: Cam processor. Connector0. Group0. Track0. Cam3
Confirmation condition Cam definition
Type: Position
Initial value: Position
ThresholdX1:
Initial value:
110
0 pulses
ThresholdX2:
Initial value: 0 pulses
Cam monitoring:
Initial value:
Initial value:
Cam still operative
Cam still operative
Confirmation bit number: 0
0
Closing delay
Initial value:
0
0
*0.1 ms
Activation condition
Forward direction
Reverse direction
Initial value
Initial value
Confirming new parameters
After modifying parameter values during debugging, the user should press the confirm button. A request is then sent to the module. The module acknowledges the modification without stopping the cam processor. The modification is in the current module parameters. Switch to "Adjust Recipe" mode to save them as initial parameters.
TLX DS 57 PL7 xx
117
Debugging and adjusting
118
TLX DS 57 PL7 xx
