PAR 1 RGBW User Manual Professional Entertainment Technology

3. Once the mode has been selected, press ENTER to set it (or press MENU to exit without making a change).

Sound activation (music trig)

The fixture’s built-in microphone can be used to trigger effect and color changes in sync with music if you enable sound activation and run the fixture in show mode.

To enable sound activation:

1. Select and press ENTER.

2. Use the DOWN and UP buttons to select (sound activation on) or

(sound activation off).

3. Press ENTER to set (or press MENU to exit without making a change).

Microphone sensitivity

To adjust the sensitivity of the sound-activation microphone to match the volume of the music:

1. Select and press ENTER.

2. Use the DOWN and UP buttons to select a sensitivity level from 0 to 100.

3. Press ENTER to set (or press MENU to exit without making a change).

DMX state

The DMX state menu lets you set the fixture’s behavior when it is powered on but is not receiving a DMX signal. You can set the fixture to:

• enter show mode and run the standalone show type selected in the show mode menu (see ’Show mode’ on page 19),

• blackout, or

• return to its last state.

When a fixture has entered one of these DMX states, it is called out of its state and responds to DMX as soon as it receives a DMX signal.

RUSH PAR 1 RGBW User Manual

21