PAR 1 RGBW User Manual Professional Entertainment Technology

4. Use the DOWN and UP buttons to change the value (125~255).

5. Once the correct value has been selected, press ENTER to set it (or press

MENU to exit without making a change).

Manual mode

The Manual menu can be used to control effects using the fixture’s control panel.

This lets you test effects and display a single scene without a DMX signal.

To manually control effects:

1. Select and press ENTER.

2. Use the DOWN and UP buttons to select (red), (green),

(blue), (white), (dimmer) or (strobe). Press

ENTER to select (or press MENU to exit without making a change).

3. Use the DOWN and UP buttons to specify a value from 0 to 255 for the selected effect.

4. Press ENTER to confirm the value and activate the effect (or press MENU to exit without making a change).

5. Each time you confirm a selection with ENTER, press MENU to go back through the menu structure.

Note that the fixture will not respond to DMX commands while you are controlling effects in the Manual menu. To restore DMX control, exit the Manual menu.

If you power the fixture off while you are controlling effects in the Manual menu, the effects are not restored and the fixture does not return to the Manual menu when you power it on again.

Auto test

To perform a complete test of all of the fixture functions:

1. Select and press ENTER. The fixture will run a self-test routine.

2. Press MENU to exit.

RUSH PAR 1 RGBW User Manual

23