advertisement
Troubleshooting
This section describes possible problems and provides some suggestions for easy troubleshooting:
Symptom
No light from fixture, or fans not working.
Fixture does not react to music beat.
Potential cause
If no DMX signal is present, fixture may be set to ‘Blackout’ DMX state.
Power supply issue, such as blown fuse, faulty connector or damaged cable.
Fixture not in show mode.
Sound activation disabled.
Sound activation microphone sensitivity too low for music source.
Fixture receiving DMX.
Remedies
Change setting in DMX state menu.
Check whether fixture’s power indicator LED is lit.
Check all power connections and cables.
Replace fixture fuse.
Set fixture to show mode in
DMX state menu.
Enable.
Adjust microphone sensitivity.
Tap microphone to check correct functionality. The fixture should react when in sound activation mode.
Stop DMX signal.
RUSH PAR 1 RGBW User Manual
33
Symptom
Fixture does not respond to DMX control.
Potential cause
Incorrect DMX addressing.
Fault on DMX link due to damaged connector or cable, or interference from proximity to a highvoltage installation.
Remedies
Ensure that fixture’s DMX address matches address set on DMX control device.
Check that fixture’s DMX
LED is on, and if not, check all cables and connections on the DMX link.
Check that DMX link is terminated.
Check that all devices on the DMX link use standard
DMX polarity.
Try to control the fixture with another DMX control device.
Move or shield link if it is close to an unshielded high-voltage installation.
34
RUSH PAR 1 RGBW User Manual
advertisement