Modem configuration
Modem configuration screen
Introduction
Illustration
This screen, split into two zones, is used to declare the communication channel and to configure the parameters necessary for a modem link.
The screen dedicated to modem communication looks like this:
TSX 57352 [RACK 0 POSITION 0]
Designation: TSX P PROCESSOR 57352
1
2
CHANNEL 1:
CHANNEL 1
UNI TELWAY LINK
TSX MDM 10 PCMIA MODEM CARD
MAST
Unitelway
Calling slave mode
Server address (AD0) 1
Number of server addresses (AD0) 2
Transmission Speed
9600 Bits/s
Wait timeout (ms)
Default 1000
Data
7 bits
8 bits
Parity
Even Odd
Stop
1 bit
2 bits
Without
Modem ...
Character mode …
Elements and functions
This table describes the different zones that make up the configuration screen:
Address Zone
1 common
2 specific
Function
See (See : PL7 Micro/Junior/Pro ; Communication applications
; Volume 1).
is used to select or complete modem link parameters.
It is split into three different types of information: l parameters concerning communication using Uni-telway protocol, l parameters concerning communication using character mode protocol l parameters concerning the modem
TLX DS COM PL7 xxE
89
