FIPIO Configuration
Properties of the FIPIO bus: Expert tab
Introduction With this tab, you have access to the management mode concerning the calculation l l of: reversal and silence time, bandwidths.
Note: At each modification of the parameters below, all the connected devices must be powered off, then on after the new application has been downloaded (in the PLC).
The automatic mode
Note: This mode is advocated.
The reversal and silence times and the bandwidths cannot be modified. They are calculated according to the bus parameters and device configuration data.
The manual mode
CAUTION
No monitoring is carried out in manual mode. Modifying these parameters can cause the device connected to the bus not to work.
Failure to observe this precaution can result in injury or equipment damage.
This mode is used to enter the reversal and silence times and the bandwidths.
It is mainly reserved for specific applications requiring these values to be modified
(example: use of Hirschmann transmittors).
TLX DS COM PL7 xxE
267
