Standard profiles
Configuration screen of a standard profile
Introduction
Illustration
The configuration screen of a standard profile reuses the parameters of all other devices configured on the FIPIO bus (see Configuration screen of an FIPIO device).
However, some parameters are exclusive to it. In the rest of this document, only the part specific to the standard profiles is explained.
The screen dedicated to the device looks like this:
FSD M8 P [FIPIO18 MODULE 0]
Configuration
Designation: EQP STD MOD 8MP
Elements and functions
1
2
3
4
Channel 0
Local configuration
Task: MAST
Default configuration
Base
Decimal
Parameter
%KW\0.2.18\0.0.0
%KW\0.2.18\0.0.1
%KW\0.2.18\0.0.2
%KW\0.2.18\0.0.3
%KW\0.2.18\0.0.4
%KW\0.2.18\0.0.5
%KW\0.2.18\0.0.6
%KW\0.2.18\0.0.7
Symbol Value
0
0
16#8040
16#0
0
0
0
16#4
This table describes the different areas that make up the configuration screen:
Address Description
1 The Local configuration check box is only available for the FSD C8 P and FSD
M8 P profiles.
If the box is checked, the configuration and adjustment parameters are not sent to the device connected to the bus (to ensure rapid start-up of the device). The device starts up or initializes with its own parameters.
In the configuration screen, if the box is checked, the parameters of the channel cannot be accessed.
2 The Default configuration button is used to return to the original configuration.
322
TLX DS COM PL7 xxE
Standard profiles
Address Description
3
4
The Standard is used to select the display standard of the value of the selected word.
Three types are available: l l l
Decimal
Hexadecimal
Binary
This list displays the configuration words %KW or the adjustment words %MW which correspond to the registered standard profile.
For each word, there is an associated Symbol and a Value.
TLX DS COM PL7 xxE
323
