Appendices
\Kn - BREAK control
Introduction
Parameters of case 1
According to the parameter entered, controls the modem response to a break signal received from the DTE, from the remote modem or from the \B command. The value of the parameter, if valid, is written in bits 3, 4 and 5 of S40. The response is different according to the case.
Code
\K0
\K1
\K2
\K3
\K4
\K5
The first case is that of the modem which receives a break from the DTE when it is in data transfer mode:
Description
Switches to on-line command mode, no break sent to the remote modem.
Empties the data buffers and sends a break to the remote modem.
As \K0.
Immediately sends a break to the remote modem.
As \K0.
Sends a break to the remote modem in sequence with the transmitted data
(default value).
Parameters of case 2
Code
\K0
\K1
\K2
\K3
\K4
\K5
The second case is that of the modem which is in on-line command mode (awaiting
AT commands) during a connection, and which receives a \B command for it to send a break to the remote modem:
Description
Empties the data buffers and sends a break to the remote modem.
Empties the data buffers and sends a break to the remote modem.
Immediately sends a break to the remote modem.
Immediately sends a break to the remote modem.
Sends a break to the remote modem in sequence with the data.
Sends a break to the remote modem in sequence with the data.
TLX DS COM PL7 xxE
177
