FIPIO Configuration
Properties of the FIPIO bus: General tab
Introduction
The profile
With this tab, you can access two types of information: l l the profile, the bus length.
The profile is chosen according to the devices which are connected to the FIPIO bus. It can be in either of two versions: l l
FIP: l This profile is chosen by default.
l It is compatible with all the devices of Schneider and partners.
WorldFip: l The selection of this mode allows you to operate the FIPIO bus in accordance with the EN 50170 standard.
l l
Note: The WorldFip profile mode can be used with the following restrictions: no TSX FP ACC6 or TSX FP ACC8 repeaters, use of TBX LEP 020 version 1.4 minimum and TBX LEP 030 version 1.2 minimum, l use of the PCMCIA TSX FPP 10 card, version 1.8 minimum.
The bus length With this cursor you can increase or decrease the bus length. The default value is 1
Km and the adjustment increment is 1 Km.
This length must be adjusted because it is taken into account in the calculation of the propagation time for the signals on the bus and consequently in the calculation of the network cycle times.
Note: At each modification of the length of the FIPIO bus, all the connected devices must be powered off, then on after the new application has been downloaded (in the PLC).
266
TLX DS COM PL7 xxE
