FIPIO Agent
Communication from an FIPIO Agent
Introduction
Addressing
A PLC registered as an FIPIO Agent can communicate: l l with the server of the bus manager, with the server of another FIPIO Agent.
The syntax of an address is as follows:
ADR#\0.1.4\SYS
The following table describes the addressing parameters:
Parameter
0.1.4
SYS
Description l l l
0: corresponds to the module sending the request
1: corresponds to the channel sending the request
4: corresponds to the destination connection point corresponds to the server address.
348
TLX DS COM PL7 xxE
Example
FIPIO Agent
Example of access the system of the different PLCs
Manager
ADR#\1.1.0\SYS
Accessing the manager server
0
ADR#\0.1.1\SYS
Accessing the
FIPIO Agent 1 server
1
ADR#\0.1.4\SYS
Accessing the
FIPIO Agent 4 server
ADR#\0.1.4\SYS
Accessing the
FIPIO Agent 4 server 4
63
The FIPIO Agent PLC at address 1 reads 10 words in the FIPIO Agent PLC at address 4.
READ_VAR(ADR#\0.1.4\SYS, ‘%MW’, 0, 10, %MW10:10, %MW100:4)
TLX DS COM PL7 xxE
349
