Appendices
11
Introduction
Aim of this
Chapter
What's in this
Chapter?
This Chapter introduces AT commands associated with the TSX MDM 10 modem.
This Chapter contains the following Maps:
Topic
AT commands
A/ - Command re-execution
AT = x - Write to the selected S register
AT? - Read the selected S register
A - Answer
Cn - Checking for carrier
Dn - Dialing
En - Local command echo
Hn - Disconnection (hang up)
In - Identification
Ln - Loudspeaker volume
Mn - Loudspeaker command
Nn - Activation of automatic mode.
On- Return to on-line data mode
P - Default adjustment of pulse dialing
Qn - Activation / deactivation of result codes
Sn - S register read / write
T - Default adjustment of tone dialing
Vn - Form of the result codes
Wn - Error correction messages control
144
145
146
147
140
141
142
143
Page
131
133
134
135
136
137
138
148
149
150
151
152
TLX DS COM PL7 xxE
129
Appendices
Topic
Xn - Extended result codes
Yn - Disconnection after prolonged inactivity
Zn - Software reset of modem and restoration of profile
&Cn - RLSD Option (detection of DCD carrier)
&Dn - DTR Option (Data Terminal Ready)
&Fn - Restoration of the factory configuration (profile)
&Gn - Selection of guard tone
&Kn – Flow control
&Pn - Selection of pulse dialing close/open report
&Qn - Synchronous/asynchronous mode
&Rn - RTS/CTS option
&Sn - DSR Monitoring (Data Station Ready)
&V - Display of current configuration and stored profiles
&Wn – Storage of the current configuration
&Yn - Designation of a default profile on reset
&Zn – Storage of telephone numbers
%Cn - Activation / deactivation of data compression
%En - Activation/deactivation of line quality monitoring or automatic resynchronization or fallback/increase of transfer rate
%L - Level of line signal
%Q - Quality of line signal
\Kn - BREAK control
\Nn - Operating mode
Values of the registers of the TSX MDM 10 card in a PLC
167
168
169
170
163
164
165
166
Page
153
158
159
160
161
162
171
172
173
174
175
176
177
179
180
130
TLX DS COM PL7 xxE
