Modbus Plus configuration
Modbus Plus configuration screen
Introduction
Illustration
This screen, split into two zones, is used to declare the communication channel and to configure the parameters necessary for a Modbus Plus link.
The screen dedicated to Modbus Plus communication looks like this:
TSX 57302 [RACK 0 POSITION 0]
Configuration
Designation: PROCESSOR TSX P 57302
1
CHANNEL 1:
CHANNEL 1
MODBUS+
TSX MBP 100 MODBUS+ PCMCIA CARD
MAST
2
Station number: : 1
Peer Cop
Value of Timeout:
Input fallback mode
Maintain
Reset to 0
500 (ms)
Specific Inputs
Specific outputs
Elements and functions
This table describes the different zones that make up the configuration screen:
Address Zone
1 common
2 specific
Function
(See : PL7 Micro/Junior/Pro ; Communication applications ;
Volume 1) is used to select or complete the parameters of a Modbus Plus link.
It is split into two types of information: l l station addressing, the parameters concerning the Peer Cop service.
TLX DS COM PL7 xxE
197
