Installation. Buffalo Tech TeraStation 5000

Installation

1

Insert the TeraNavigator CD into your computer. TeraNavigator will launch.

2

Click Begin Installation.

3

Follow the steps on the screen to connect the TeraStation’s Ethernet and power cables and turn it on.

Note: Use LAN port 1 for initial setup. After setup, you may connect a second cable to LAN port 2. If you use LAN port 2, configure the IP address at Network - IP Address in Settings.

4

Follow the steps on the screen to install NAS Navigator2.

5

Click Finish. NAS Navigator2 will open.

6

Right-click on your TeraStation’s icon and choose Properties.

Note: For Mac OS, select the TeraStation’s icon while holding down the control key, then click Configure.

7

Click the IP Address tab, enter the desired settings, and click OK.

13

If you are prompted to enter the administrator password for the TeraStation, it is “password” by default.

8

Right-click on your TeraStation’s icon and choose Settings.

9

Changing the password from the default is recommended.

10

Go to Management - Name/Time/Language and configure the TeraStation’s time and date.

14