Logs. Buffalo Tech TeraStation 5000

Note: All data on the USB flash drive will be erased!

4

Select the USB memory device from “Target USB drive” list, then click Execute.

5

Enter the 4 digit confirmation number and click OK. The TeraStation will create the password reset drive. This will take about a minute.

6

When the “finished” dialog opens, the password reset drive is ready to use. Dismount the USB drive before unplugging it. See “Dismounting Drives” in chapter 4 for the instructions on dismounting drives.

Resetting with the USB Drive

To reset your admin password, follow the procedure below.

1

Create a USB “password initialization” drive as described above.

2

Insert the USB drive into a USB 2.0 port (not a USB 3.0 port) on the TeraStation.

3

Set the boot mode switch to “USB”.

4

Press the power button to turn on the TeraStation.

5

When the message “Recovery I41 PushFuncToStart” appears on the LCD panel, press the function button.

6

The password will be reset to its factory default. The TeraStation will shut down when it’s finished.

7

After shutdown, “Recovery I39 Change Boot” is displayed.

8

Set the boot mode switch to “HDD” position.

9

Press the power button to start the TeraStation.

Logs

Follow this procedure to check the TeraStation’s logs.

1

In Settings, click Management.

2

Click to the right of “Logs”.

3

Click Edit.

4

Select a log to view.

158