Turning the TeraStation On and Off. Buffalo Tech TeraStation 5000

Notes:

• For best results, use an NTP server to maintain the time settings on the TeraStation and other network devices.

Clocks for the network devices may run at slightly different speeds. If these devices get out of sync it may cause network problems.

• Buffalo is not responsible for any losses and damages incurred from using the ntp.jst.mfeed.ad.jp service or service outages.

• If the TeraStation cannot automatically obtain the time from an NTP server, check its DNS settings. If the NTP server is specified by a hostname instead of an IP address, make sure that a DNS server address is configured in

Network - IP Address.

In NAS Navigator2, double-click your TeraStation’s icon. This will open the shared folder of the TeraStation. For Mac

OS, the TeraStation is mounted as a drive icon on the desktop or it is displayed in the sidebar of the Finder. You can now use the TeraStation’s shared folder to save files just like any other folder.

Turning the TeraStation On and Off

Press the power button on the TeraStation to turn it on.

To turn off the TeraStation, press the power button twice. Don’t unplug the TeraStation without turning it off first. You can also shut it down and restart it remotely from Settings.

Shutdown or Restart from Settings

Double-click the icon.

Right-click your TeraStation’s icon and select Settings. For Mac OS, select the TeraStation’s icon while holding down the control key, then select Settings.

Enter the username and password, then click OK.

Note: The default username and password are “admin” and “password”.

Settings will open.