16.11 Changing the high beam bulb. KTM 1290 Super Adventure, 1290 Super Adventure 2016

16 ELECTRICAL SYSTEM

–

Plug connector

 into the new headlight bulb.

Low beam (H11/socket PGJ19-2) ( p. 237)

–

Position headlight bulb

 into the bulb socket and turn it all the way clockwise.

The headlight bulb is locked into the bulb socket.

196

M00851-10

Finishing work

–

Install the headlight mask with the headlight. ( p. 193)

–

Position the mask spoiler. ( p. 142)

–

Install the wind shield. ( p. 150)

–

Check the setting of the lighting system. ( p. 199)

16.11

Changing the high beam bulb

Note

Damage to reflector

Reduced brightness.

–

Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before mounting.

Preparatory work

–

Switch off all power consumers and switch off the engine.

–

Remove the wind shield. ( p. 150)

–

Loosen the mask spoiler. ( p. 140)

–

Remove the headlight mask with the headlight. ( p. 191)

16 ELECTRICAL SYSTEM

Main work

–

Push headlight bulb wise, and pull it out.

 lightly into the bulb socket, turn it all the way counterclock-

–

Unplug connector



.

197

M00853-10

–

Plug connector

 into the new headlight bulb.

High beam (H11/socket PGJ19-2) ( p. 237)

–

Position headlight bulb

 into the bulb socket and turn it all the way clockwise.

The headlight bulb is locked into the bulb socket.

M00852-10

Finishing work

–

Install the headlight mask with the headlight. ( p. 193)

–

Position the mask spoiler. ( p. 142)

–

Install the wind shield. ( p. 150)

–

Check the setting of the lighting system. ( p. 199)