16.12 Changing the turn signal bulb. KTM 1290 Super Adventure, 1290 Super Adventure 2016

16 ELECTRICAL SYSTEM

198

16.12

Changing the turn signal bulb

Note

Damage to reflector

Reduced brightness.

–

Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease before mounting.

M00854-10

–

Remove the screw on the front of the turn signal housing.

–

Carefully remove diffuser



.

–

Press bulb

 carefully into the socket, turn it counterclockwise by about 30°, and pull it out of the socket.

Info

Do not touch the reflector with your fingers, and keep it free from grease.

–

Press the new bulb carefully into the socket and turn it clockwise until it stops.

Turn signal (RY10W / socket BAU15s) ( p. 237)

–

Check the turn signal to make sure it is functioning properly.

–

Position the diffuser.

Info

Hook in projection

 at recess



.

–

Insert the screw and first turn it counterclockwise until it engages in the thread. Tighten the screw slightly.