16.13 Checking the setting of the lighting system. KTM 1290 Super Adventure, 1290 Super Adventure 2016

16 ELECTRICAL SYSTEM

16.13

Checking the setting of the lighting system

–

Position the vehicle upright on a horizontal surface in front of a light wall and make a mark at the height of the center of the low beam headlight.

–

Make a second mark at a distance  under the first mark.

Guideline

Distance



5 cm (2 in)

199

402424-10

–

Make two further marks spaced apart ing.

 to the left and the right of the second mark-

Guideline

Distance



71.5 cm (28.15 in)

402426-10

16 ELECTRICAL SYSTEM

402425-10

200

–

Position the vehicle perpendicular to the wall at a distance on the low beam.

 from the wall and switch

Guideline

Distance



5 m (16 ft)

–

The rider, with luggage and passenger if applicable, now mounts the motorcycle.

–

Check the headlight setting.

The light-dark boundary of the low beam must lie exactly on the lower mark when the motorcycle is ready to operate with the rider mounted along with any luggage and a passenger if applicable.

» If the boundary between light and dark does not meet specifications:

–

Adjust the headlight range. ( p. 201)

–

Press the

UP

or

DOWN

button until the

"Settings"

menu appears on the matrix display.

Pressing the

SET

button opens the menu.

–

Press the

UP

or

DOWN

button until

"cLightTest"

is highlighted in black on the matrix display. Pressing the

SET

button again starts the cornering light test.

–

Wait for a few seconds until the upper segment of the left cornering light lights up continuously.

–

Checking the left cornering light setting.

The light-dark boundary of the upper segment must run exactly through the left marking.

» If the boundary between light and dark does not meet specifications:

–

Adjust the cornering light range. ( p. 202)

–

Press the

SET

button.

The left cornering light is switched off.

The right cornering light test is started.

402427-01