advertisement
Two-sided seating with dowel (76)
Connects a column and two beams using anchor bolts.
Parts created
• Anchor bolts (2)
• Nuts (2)
• Washer plates (2)
• Bearing plates (2)
• Fittings for beam and column (2)
• Holes for bolts (2)
• Corbels (optional) (2)
• Recesses for washer plate and nut (optional) (2)
Where to use
Option Description
Connects two beams to a column using anchor bolts and creates corbels. Nuts and washer plates on the surface of the beams.
Connects two beams to a column using anchor bolts.
Nuts and washer plates recessed into the beams.
Second beam is sloped, and is cut to create a gap between the beam and the column.
Before you start
Create the following parts:
• Concrete column (round or rectangular profile)
• Two concrete beams (rectangular, HI, I, L, or inverted T profile)
Concrete Detailing 19 Seating connections
Defining properties
Use the tabs in the Two-sided seating with dowel (76) dialog box to define the following properties:
Tab
Picture
Contents
Dimensions defining the position of the anchor bolts relative to the beams and bearing plates.
Options to cut and shape the ends of the beams and to fit column or beams.
More information
To use the same dimensions for both beams, set Use the same parameters for left and right
beams to Yes and enter the dimensions for the left beam only.
Parts
Left beam
Right beam
Corbel
General
Analysis
Bearing plate, bolt, nut and anchor bolt properties
Left beam is the first beam picked and right is the second.
Anchor bolt, bolt hole and recess properties.
Clearance between beam and column if beam is sloped.
Option to create corbel, corbel properties
Information needed for structural analysis
General tab
Analysis tab
Picking order
1. Column
2. Beam 1
3. Beam 2
Click the middle mouse button to finish picking and create the connection.
Concrete Detailing 20 Seating connections
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement