Concrete Detailing - Tekla User Assistance

Detect negative volume

If a negative volumne is applied to the concrete panel, you can define is this negative volume should be recognised or not.

In below example a Part Cut is added with depth of 110 mm. If the value field is set to 0, the rebars can not be placed correctly.

If the value field is set equal or greater to the part cut depth (e.g. 110), the panel thickness will be recognised and the rebars are placed correctly.

Difference in thickness

= 0

Difference in thickness

= 110

CS Components 772 Border rebar for single edge (93)