Concrete Detailing - Tekla User Assistance

The second position point is needed to complete the input also if you have selected an option for only one input point in the component dialog box. In this case, the second point location does not matter.

The opening is created automatically when the second position is picked.

Part identification key

1

2

3

Sandwich wall element

First picked position

Second picked position

Part

Picture tab

Use the Picture tab to control the dimensions and parts of the opening.

Dimensions

Option

Create Window

Dimensions

Concrete Detailing 192 Panels and walls

Option

Create Window +

Door

Set the Door

location to Right

side or Left side.

The options on the

Door side detail tab and Door bottom

detail tab are available when you set the Create option to Window +

Door.

Dimensions

3

4

5

6

7

1

Option

2

Description

Set the points for the opening:

• 2 points

Pick two points to create the opening (points 2 and 3 in the image).

• Point 1 B H

Pick two points to create the opening. With this option, point 2 shown in the image is the reference point. Point 3 is only needed to complete the input. Define the width and height of the opening.

• Point 2 B H

Pick two points to create the opening. With this option, point 3 shown in the image is the reference point. Define the width and height of the opening.

• 2 Points H

Pick two points to create the opening (points 2 and 3 in the image). Define the height of the opening.

Vertical offset from the insertion point.

When you create Window + Door, this is the vertical offset for the window.

Horizontal offset from the insertion point.

Width of the opening.

When you create Window + Door, this is the width of the window.

Height of the window.

Width of the door.

Vertical offset for the door.

Concrete Detailing 193 Panels and walls