Concrete Detailing - Tekla User Assistance

Defining properties

The component contains only one tab, named Picture.

Tab

Picture

Content

Defining the cut direction.

Possibly set an cutplane offset.

See also

Picture (page 738)

Picking order

1. Concrete part

2. Three points to determine the cut plane.

Picture

On the Picture tab the following can be set:

Definition of the cut

Cut right

The parts’ right side from the cut plane will be removed.

Cut left

The parts’ left side from the cut plane will be removed.

Fit plane

The removed part is shortest part (from fit plane to part’s end).

No cut

No cut is applied.

Offset

An offset can be applied for the cutplane. The offset distance is always perpendicular to the cutplane.

No Offset

CS Components

Offset set to 50 mm

738 3D cut (10)