Concrete Detailing - Tekla User Assistance

Select other layers

Option Description

Insulation, Wall Parts where the opening is created.

To create the opening to the insulation and the external layer parts, enter the class numbers.

Foil

If you do not enter any numbers, the opening is only created to the part you selected when applying the component.

You can use Sandwich wall window both for sandwich panels with a foil and for sandwich panels without a foil

(default). If you have a sandwich panel with a foil, select Yes and enter the class number of the foil.

The frame shape options shown on the Bottom detail,

Left detail, Right detail, and Top detail tabs depend on whether the foil is created or not.

Bottom detail tab / Left detail tab / Right detail tab

Use the Bottom detail tab, Left detail tab, and Right detail tab to control the size, position and shape of the opening bottom, left side, and right side, and the frame size and properties. On the Right detail tab, you can select that the right detail is created the same as the left detail.

Frame

Part

Frame

Description

Define the frame profile by selecting the profile from the profile catalog.

50*50

Default

Pos_No

Option

Material

Name

Class

Description

Prefix and start number for the part position number.

You can enter the assembly position number on the second row.

Material grade.

Name that is shown in drawings and reports.

Part class number.

Frame shape

The options for inner and outer frame are the same regardless of whether the foil is created or not.

Concrete Detailing 194 Panels and walls

Inner Outer Description

Default

Cut or extension is not created.

AutoDefaults can change this option. Any of the three options is used depending on the frame size.

Cut or extension is not created.

Extension is created.

If the frame is narrower than the insulation, the concrete part is extended to fill the gap.

Cut is created.

If the frame is wider than the insulation, the concrete part is cut so that the frame fits.

Concrete Detailing 195 Panels and walls

Middle Description

This option is available when the Foil option is set to Do not create on the

Picture tab.

Frame is created.

This option is available when the Foil option is set to Do not create on the

Picture tab.

Frame is not created.

This option is available when you select Yes in the Foil option on the

Picture tab.

Frame is created.

This option is available when you select Yes in the Foil option on the

Picture tab.

Frame is created.

This option is available when you select Yes in the Foil option on the

Picture tab.

Frame is not created.

Concrete Detailing 196 Panels and walls

Additional recess

Define the vertical and horizontal dimensions for the additional recess. By default, the recess is not created.

Frame corner cuts

Option Description

Frame corners are not cut.

Define the horizontal and vertical dimensions of the frame corner cuts.

Continuous slope

Select whether frame edges are sloped.

Option

By length

Description

By angle

You can set the length or the angle for both sides separately.

The default is that frame edges are not sloped.

Concrete Detailing 197 Panels and walls