advertisement
Viewing the Graph
Graph Display: <List> button / [Data List]
1. Press the <List> button on the RTR-500DC or open [Data List] in the Main Menu to view the Data List.
2. Select data from the list and click [Graph Display] to view the data in graph form.
- Press the Operation Dial to cancel the Graph Display.
How to Read the Graph
A graph is displayed for each channel of data.
Cursor Line (blinking)
By moving the Operation Dial, you can scroll the cursor line left and right.
Channels for Display
If there are multiple channels of recorded data, you can change the channel on display by holding in the Operation Dial (for about one second).
Recording Interval and Mode
The "Recording Interval" and "Recording Mode" for the displayed data are shown here.
Example: = 2-second interval, One Time Mode
= 30-minute interval, Endless Mode
Date and Time of Cursor Position
The date and time of the current cursor position are shown here.
Graph Display Range
When a portion of the graph has been zoomed-in on, this line shows the range of data currently on display from the entire range of recorded data.
Upper Limit / Lower Limit
If Upper and/or Lower Limits have been set in the Remote Units, these limits will be shown using thick dotted lines.
VIewing Functions 59
Measurement at Cursor Position
The corresponding measurement value is displayed for the date and time where the cursor is positioned.
Temperature: °C , °F
Humidity: %RH
Illuminance: lx, klx
UV Intensity : mW/cm 2
CO2 Concentration : ppm
Voltage : V
4-20mA : mA
Pulse : Pulse (Rising), Pulse (Falling)
60 Viewing Functions
advertisement
Related manuals
advertisement