advertisement
Twin Disc, Incorporated
Component Installation
Control Head Lever Drag Adjustment
1.
2.
Adjust drag as needed. Refer to Figure 7 and 8 for drag adjustment screw locations.
Access the drag adjustment screw and insert an 1/8 in. hex key wrench into the opening for each lever. Remove the access screw on side mount control heads. See Figure 7 and Figure 8.
3.
Tighten the drag adjustment screw(s) until the desired drag is obtained over the full lever travel.
Note: 0.45 to 0.91 kg (1 to 2 lb) average drag is normally desirable.
DRAG ADJUSTMENT
DRAG ADJUSTMENT
Figure 7. Drag Adjustment Screws for Single/Dual Lever Control Head
REMOVE SCREW
TO ACCESS
DRAG ADJUSTMENT
Figure 8. Drag Adjustment Screws for Side Mount Control Head
Assembly
EC300 Marine Control System Installation Manual #102416
35
advertisement
Key Features
- Remote throttle control
- Transmission engagement control
- Engine Sync
- Trolling
- Shaft Brake
- Mechanical Actuator Output
- Transmission Oil Pressure and Oil Temperature Monitoring
- Helm Display
Related manuals
Frequently Answers and Questions
What types of vessels is the EC300 Marine Control System suitable for?
What types of engine/transmission combinations is the EC300 Marine Control System compatible with?
What are some of the special features of the EC300 Marine Control System?
advertisement